Hello Sergey,

On Thu, 2 Dec 2010 21:08:09 +0300, "Sergey V. Efimoff" risky@mail.ru wrote:

I had once or twice seen BTS stations which had working PLL value very different from calibrated value. In order to get them close I had to use E1 hardware with high precision oscillator, then switch the hardware to the PLL-locked mode. This operation took me plenty of time.

Please tell, is it possible to set the working PLL value directly?

Yes, bs11_config supports this. Its the "pll-workvalue" command. The way how the PLL workvalue could be set was not obvious so it took a while till we found out how this could be done. Thats the reason why it took quite long till this command was introduced.

Best regards, Dieter