2 Dec
2010
2 Dec
'10
8:22 p.m.
Hello Sergey,
On Thu, 2 Dec 2010 21:08:09 +0300, "Sergey V. Efimoff" <risky(a)mail.ru>
wrote:
I had once or twice seen BTS stations which had working PLL value
very different from calibrated value. In order to get them close I had to
use E1 hardware with high precision oscillator, then switch the
hardware to the PLL-locked mode. This operation took me plenty
of time.
Please tell, is it possible to set the working PLL value directly?
Yes, bs11_config supports this. Its the "pll-workvalue" command. The
way how the PLL workvalue could be set was not obvious so it took a
while till we found out how this could be done. Thats the reason why
it took quite long till this command was introduced.
Best regards,
Dieter
--
Dieter Spaar, Germany spaar(a)mirider.augusta.de