-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
Hi,
I tested rev. 458 and was able to switch the PLL mode from E1-locked to standalone.
Unfortunately I see the same behavior (even with restarting the BS-11) as in E1-locked ('hfcmulti' and 'hfcmulti port=0x200) - a network scan shows either your BS-11 or the other networks and only sometimes you see all networks
This time I found the local net after 5-10 minutes with a Nokia 9300i and E70. My 6110 could only see the other networks.
Voice works fine in this revision, there is only some delay. But I observed some strange behaviour using call hold - when you activate it on a phone the other party can still hear you. :)
Regards, Christian
Harald Welte wrote:
We could add this setting to the bs11_config program so people can
try if
their E1 clock or their [10 years uncalibrated] BS11 internal
oscillator is
better.
However, since it doesn't change any common code paths, I have
committed it.
It would be great if somebody could do some testing if this actually
works.
I've tested (+fixed) it now. 'query' now also shows the current PLL Mode configuration (as of SVN rev. 455)