Hi all,
I have followed the the guide in network_from_scratch and use 1 osmocom phone as transceiver. I use the suggested configs for open-bsc.cfg and osmo-bts.cfg and can register to the network I run.
However in the output from osmo--nitb ,in the start I get a message about the training sequence: ________________________________________________
% This BTS does not support a TSC!=BCC, Falling back to BCC and after the
DB: Database initialized messages DB: Database prepared ---------------------------------- --------------------------------
<0005>bsc.init.c:265 bootstrapping RSL for BTS/TRX(0/0) on ARFCN 533 using MCC=1 MNC=1 LAC=1 CID=0 BSIC=63 TSC 7 ------------------------------------------ <0002> gsm.subscriber.c: 378 Subscriber <imsi> ATTACHED LAC=1 -----------------------------------------------------------------------------------------------------
I have entered hlr.sqlite and assigned an extension to my imsi but when I enter the VTY and execute enable
subscriber imsi <imsi> sms send test123 I get: %Unknown command So it appears smsqueue is not enabled. Does anyone know what to look for to enable it? I have tried the vty commands trigger smsqueue but to no avail.. According to the network from scratch wiki sms (and broadcast) should function with one phone where TS0 is served -------------------------------------------------------------------
osmo-bts-trx outputs lines of
<0006> scheduler.c 338 ---- chan=SDCC/4(0) --- chan=SACC/4(0) ----- chan=BCCH(0) ---------------------------------------------------------------------------------------------------------- When the firmware is loaded onto the phone I get time on arrival and signal to noise ratio messages: TOA=4 snr=16384 (Thres 2560) freq_err=40 pm=-70 -------------------------------------------------------- So that is grossly exceeding the threshold value. But is that related to not being able to use smsqueue?
Regards Erich