Hi all,
I have followed the the guide in network_from_scratch and use 1 osmocom phone as
transceiver. I use the suggested configs for open-bsc.cfg and osmo-bts.cfg and can
register to the network I run.
However in the output from osmo--nitb ,in the start I get a message about the training
sequence:
________________________________________________
% This BTS does not support a TSC!=BCC, Falling back to BCC
and after the
DB: Database initialized messages
DB: Database prepared
----------------------------------
--------------------------------
<0005>bsc.init.c:265 bootstrapping RSL for BTS/TRX(0/0) on ARFCN 533 using MCC=1
MNC=1 LAC=1 CID=0 BSIC=63 TSC 7
------------------------------------------
<0002> gsm.subscriber.c: 378 Subscriber <imsi> ATTACHED LAC=1
-----------------------------------------------------------------------------------------------------
I have entered hlr.sqlite and assigned an extension to my imsi but when I enter the VTY
and execute
enable
subscriber imsi <imsi> sms send test123
I get:
%Unknown command
So it appears smsqueue is not enabled. Does anyone know what to look for to enable it?
I have tried the vty commands trigger smsqueue but to no avail..
According to the network from scratch wiki sms (and broadcast) should function with one
phone where TS0 is served
-------------------------------------------------------------------
osmo-bts-trx outputs lines of
<0006> scheduler.c 338 ---- chan=SDCC/4(0)
--- chan=SACC/4(0)
----- chan=BCCH(0)
----------------------------------------------------------------------------------------------------------
When the firmware is loaded onto the phone I get time on arrival and signal to noise
ratio messages:
TOA=4 snr=16384 (Thres 2560) freq_err=40 pm=-70
--------------------------------------------------------
So that is grossly exceeding the threshold value.
But is that related to not being able to use smsqueue?
Regards
Erich
Show replies by date