hi my 2nd bs11 doesnt work. the boot screen from bs11_config looks like this(attached pic). both boot screens look like that, the operational one too. the 2 bs11 are connected identical, the software is the same. one works, the other doesnt. bad! the bootstrapping works on both, but the handy can only detect the one of two bs11.
troubleshooting advices are welcome, openbsc website was no help
T.
troubleshooting advices are welcome, openbsc website was no help
The clock of the non working one might just be too off ...
See http://openbsc.osmocom.org/trac/wiki/isdnsync for a tool to calibrate (with appropriate HW).
If you don't have the equipement ... huh, good luck. You can always try random values until it works. If you have a USRP you can try to lock onto it and compare offset ...
Cheers,
Sylvain
Hello,
Try to check your E1 connection and impedance (see jumpers).
Sergey.
On Dec 1, 2010, at 6:24 PM, Thomas Ansorg wrote:
hi my 2nd bs11 doesnt work. the boot screen from bs11_config looks like this(attached pic). both boot screens look like that, the operational one too. the 2 bs11 are connected identical, the software is the same. one works, the other doesnt. bad! the bootstrapping works on both, but the handy can only detect the one of two bs11.
troubleshooting advices are welcome, openbsc website was no help
T.
-- Wer Rechtschreibfehler findet, darf sie behalten! <dsc00006.jpg>
-
Sergey V. Efimoff -
Sylvain Munaut -
Thomas Ansorg