Hello friends,

I've tried to get openbsc running on CentOS, but because of a missing driver (which interfaces between libdbi and sqlite3) it was not a succes. So I removed CentOS and installed Debian Lenny, as I kinda noticed most of you work with Debian.

Anyway I managed to install and configure the openbsc with some exceptions. Because I don't use BS-11, but a nanoBTS instead, so I didn't patched the kernel for the mISDN card.

I tried the ipaccess-find first, which worked (after I modified my ip hardcoded in the source). Than I tried to configure the nanoBTS using the ipaccess-config as described in this site http://bs11-abis.gnumonks.org/trac/wiki/nanoBTS, but with our ip addresses ofcrouse. That seems to work, but the program doesn't return, I don't know if that is the case. I assume I get response if the nanoBTS gets connected with the OpenBSC.

Than I executed the bsc_hack for the nanoBTS (thus I give the appropriate parameters as described on the webpage), and I get the following error: DB: Database initialized. DB: Database prepared. mi_setup could not open socket Address family not supported by protocol

Can someone please tell me where to look at? If it's a simple error, just tell me which source does something with mi_setup, otherwise more info would be fine. Thank you.

P.S.: I'm a bit new to Linux, so please be patient with me.