Ericsson RBS-2206 startup with OSMO

Hello all! I'm still trying to bring onAir any of BTS in lab. Today we were trying with Ericsson RBS-2206. We limited hardware to the minimal possible setup containing: DXU-21 dTRU-1800 CDU-G 1800 And we created IDB with 1 cell 1TX 2RX After it we tried to use default config from master branch initially created for RBS-2308. It worked pretty fine except RF Power which was configured as 41dBm and 41 - 12 = 29 dBm. Value 29 was not acceptable for our RBS. I checked with Ericsson BSC Doc and found that our RBS2206 has max RF output 47dBm for DCS1800. (btw, RBS2308 has only 34dBm max output according to the same document, maybe config needs to be corrected) After setting 47dBm to config, TX-0 was configured correctly and Operational led was on. The main problem we are faced now is unavailability to perform "Enable"action on TX and RX objects and all next steps are not successful too. After getting logs from RBS (all files are attached) I see that TX and RX enabling fails with line: [20-11-03 11:51:27.264] 0\RC_HWU_TX hwu_tx_state.c:223 TRACED:TX Enable FAILED!, RCFW_ATC_State NOT Synchronized Looks like internal oscillator is not ready. So, the question is how to make internal oscillator synchronized? Could it be an E1 Sync stability issue caused by Digium cards? I remember we discussed it on earlier steps of bringing up OSMO-BSC. Now I have just 2 ideas what to do: 1. Set Digium card to get Sync from RBS. Now Digium is configured for Internal clocking and acts as master. Maybe in case when both sides will be configured to get sync from E1 it will decrease difference between internal clock of RBS and E1 and RBS will get Synced state. 2. Theoretically I can try to use Nokia DX200 BSC as a clock master for Digium and deliver sync to RBS from Digium. I'm not sure if timing accuracy is the same for Nokia and Ericsson HW. One more question is where can I find some info about timing accuracy for BTS and any possible way to check it on the existing E1 line? Thank you Babanov Ivan