10 Nov
2015
10 Nov
'15
8:50 p.m.
On Wed, Nov 04, 2015 at 11:32:59AM +0500, Amber and Sarosh wrote:
Hi,Can someone inform us if the VTY configuration
commands to change
parameters e.g. cell id, location area code, MS power etc. that are
run on OpenBSC VTY telnet interface take effect on next restart of
the OpenBSC session or during the same session? If former is the case,
is there any way to dynamically change Cell ID, LAC, MS TX power etc
i.e. without restarting the OpenBSC session?
* you don't need to restart openbsc to change any parameter
* some parameters (almost all under the bts/trx/ts nodes) are
communicated via A-bis OML at BTS connection time.
Those parameters are not becoming effective until the BTS re-connects
and thus goes throug OML initialization. There is a vty command that
you can use to drop the a-bis OML connection for a specific BTS.
* other parameters (affecting OpenBSC behavior directly) become
effectively immediately.
--
- Harald Welte <laforge(a)gnumonks.org> http://laforge.gnumonks.org/
============================================================================
"Privacy in residential applications is a desirable marketing option."
(ETSI EN 300 175-7 Ch. A6)