Hi Thomas,
On Fri, Dec 17, 2010 at 05:41:04PM +0100, Thomas Ansorg wrote:
BPORT0 ATTRIBUTES: Line Configuration: Multi-Drop (1)
BPORT1 ATTRIBUTES: Line Configuration: Multi-Drop (1) LMT LOGOFF: ACK
this is looking fine.
the 2nd bts said this: BPORT0 ATTRIBUTES: Line Configuration: Multi-Drop (1)
BPORT1 GET ATTR NACK LMT LOGOFF: ACK
as you can see, i set the port to 0 on both, bts1 works on ts1, tei 25 and bts2 on ts6, tei 26.
Why do you configure the 2nd BTS to multi-drop mode?
The 2nd BTS is at the _end_ of the line, and thus has to be configured like a 'single bts' setup !
Only those BTS that have to pass the E1 signal from BPORT0 to BPORT1 need their BPORTs in mult-drop mode.
does this configuration match with the attached config-file?
i think it does.
there is a strange errormessage at the end of bts2 report, a possible problem? anyway, i wasnt able to create a bport, neither in connected nor disconnected mode
You do not need a BPORT1 on the 2nd bts (at the end of the chain).
Now the final question: Did you patch your hfcmulti kernel driver? What kind of module load parameters do you use in order to run D-channels on multiple E1 timeslots?