Hello everybody,
finally i found some time to unwrap my precious BS-11 and started playing. Unfortuantely i did not get to far... I managed to build the power cable, install the antenna, hook up the serial cable to a debian box and install the openbsc software.
I followed the steps in the wiki, e.g. run "bs11_config -p /dev/ttyS0" and then turn on the BS-11. The green power LED on the BS-11 is solid green. But i do not get any output from the bs11_config (e.g. no booting messages, etc). :-( Sometimes bs11_config segfaults when i switch on the power to the BS-11:
bs11_config -p /dev/ttyS0 bs11_config (C) 2009 by Harald Welte and Dieter Spaar This is FREE SOFTWARE with ABSOLUTELY NO WARRANTY
Invalid length in hdr: 0 Segmentation fault
The serial cable is connected to the serial port (1 of 4) which is closest to the antenna connectors (like i have seen it on the photo).
What did i do wrong?
Thanks in advance for your help. :-)
Mit freundlichen Grüßen