AW: layer 1 debugging

BN1E1 seems to have different layouts over the time. i always jumper the cards to TE, so i use a crosslink cable for NT to TE. ________________________________ Von: openbsc-bounces(a)lists.gnumonks.org [mailto:openbsc-bounces@lists.gnumonks.org] Im Auftrag von Eric Cathelinaud Gesendet: Mittwoch, 10. Juni 2009 10:41 An: Harald Welte Cc: openbsc(a)lists.gnumonks.org Betreff: Re: layer 1 debugging I tried to short the left and to invert the twinax plug (thus pluging them as in the wiki) and it works too. Then it could be a mistake in the jumper plan of BN1E1 cause they say that the left is "TE" and not "NT". Anyone else dealing with a BN1E1 card to confirm? Eric Cathelinaud 2009/6/9, Eric Cathelinaud <e.cathelinaud(a)googlemail.com>om>: 2009/6/9 Harald Welte <laforge(a)gnumonks.org> Hi Eric, On Tue, Jun 09, 2009 at 12:56:25PM +0200, Eric Cathelinaud wrote: helped me a lot since i checked the step 3 and find I think there is a http://bs11-abis.gnumonks.org/trac/wiki/BS11_Configuration : straight cable) straight cable) I think that depends on the jumper configuration of your E1 card. Did you really put the jumpers in "NT Mode" configuration? Yes I put NT Mode following the jumper plan (short pins on the right). My card is a Beronet BN1E1. I will try to short pins on the left and let you know if working as in wiki. lot. great! -- - Harald Welte <laforge(a)gnumonks.org> http://laforge.gnumonks.org/ ======================================================================== ==== "Privacy in residential applications is a desirable marketing option." (ETSI EN 300 175-7 Ch. A6)