1 Jul
2016
1 Jul
'16
3:19 p.m.
Hello,
I have installed all the thing and I get the main API:
How to configure in order to see LoRa trafic?
(if I click on aquisition, I get an error message "no sample source
configured")
Maybe a quickstart help exists?
Thanks,
Loïc
20 Jul
20 Jul
12:06 a.m.
Hello,
Hi!
I have installed all the thing and I get the main API:
What do you mean by „get the main API“?
How to configure in order to see LoRa trafic?
If
you mean LoRaWAN (I never looked at it before) I think you should expect the signal to be
around 868 MHz if you’re in Europe and 915 MHz in the US [1]. You have to set this
frequency in the rotary digit display on the left either by typing, scrolling the mouse
wheel while hovering the mouse pointer over a digit by or selecting a digit and using the
up or down arrow keys. (Note: You have to enter the frequency in kHz!)
But this first requires sample acquisition to be running which comes to you error
message:
(if I click on aquisition, I get an error message
"no sample source configured“)
The error message you get on starting sample
acquisition probably means that there was no SDR device found.
What software defined radio device are you using?
Maybe a quickstart help exists?
I fear there is
no more information available than provided on the sparse website :(
Maybe posting relevant output in the console might help.
Regards
Martin
2 Aug
2 Aug
4:04 p.m.
Hello,
Le 20/07/2016 à 00:06, Martin Müller a écrit :
I try again to install
sdrangelove in order to see LORA trafic with a
HackRF.
Yes, I think my problem is with the sample acquisition because I cannot
change the frequency by scrolling my mouse
I am using one HackRF
Hello,
Hi!
I have installed all the thing and I get the main
API:
What do you mean by „get the main API“? How to configure in order to see LoRa trafic?
If you mean LoRaWAN (I never looked at it before) I think you should expect the
signal to be around 868 MHz if you’re in Europe and 915 MHz in the US [1]. You have to set
this frequency in the rotary digit display on the left either by typing, scrolling the
mouse wheel while hovering the mouse pointer over a digit by or selecting a digit and
using the up or down arrow keys. (Note: You have to enter the frequency in kHz!)
But this first requires sample acquisition to be running which comes to you error
message: (if I click on aquisition, I get an error message
"no sample source configured“)
The error message you get on starting sample
acquisition probably means that there was no SDR device found.
What software defined radio device are you using? Maybe a quickstart help exists?
I fear
there is no more information available than provided on the sparse website :(
Maybe posting relevant output in the console might help.
Regards
Martin
3359
days inactive
3391
days old
2 comments
2 participants
participants (2)
-
loic.cloatre -
Martin Müller