osmocom app GUIs don't look correct

Hi everybody, I have a problem. Yesterday I installed Fedora 20 (x86_64) laptop the following, bladeRF from nuand, and UHD + GnuRadio + gr-osmosdr + gr-iqbal etc... using Marcus Leech's build-gnuradio script. "$ wget http://www.sbrac.org/files/build-gnuradio && chmod a+x ./build-gnuradio && ./build-gnuradio" I know have installed the following versions. 1) bladeRF: libbladeRF 1.4.0 bladeRF-cli 1.2.0 FPGA: 0.3.0 Firmware: 1.8.0 GnuRadio 3.7.7 UHD 3.9.0 I am running the osmocom_fft utility on both the Ettus B210 and the bladeRF. osmocom_fft -a bladerf=0 -s 1M -f 947M osmocom_fft -a uhd -s 1M -f 947M Both seem to be running fine except that the GUI does not look correct. Please see attached images showing two screen shots of the osmocom_fft GUI. Nuand bladeRF: Center Frequency and Gain Settings are messed up. Text and sliders missing, and the boxes with the actual values are not in the right location. Ettus B210: Center Frequency and RX Gain are messed up.Text and sliders missing, and the boxes with the actual values are not in the right location. Side note: uhd_fft runs without any problems (on the B210) and the GUI looks correct. Nothing is missing or in a strange location on the screen. What can be causing this? How can I fix it? Thank you for your consideration Reagards, Urban Hakansson Senior Software Engineer Tecore Networks Phone: +1 410 872 6315 Fax: +1 410 872 6010 Email: uhakansson(a)tecore.com This e-mail may contain privileged, confidential, copyrighted or other legally protected information, and is intended exclusively for the intended recipient. If you are not the intended recipient (even if the e-mail address above is yours), you may not review, store, use, copy, disclose or retransmit it in any form. If you are not the intended recipient or otherwise have received this by mistake, please immediately notify the sender by return e-mail (or sysadmin(a)tecore.com), then delete the message in its entirety. Thank you.