Good to hear. I was also able to get my serial cable fixed so I can finally speak to the
CLI on the hardware.
?
Supported commands:
tuner.init -- Initialize the tuner
tuner.freq -- Tune to the specified frequency
tuner.gain -- Tune to the specified gain
tuner.flt_bw_mix -- Filter bandwidth (Mixer)
tuner.flt_bw_chan -- Filter bandwidth (Channel)
tuner.flt_bw_rc -- Filter bandwidth (RC)
si570.freq -- Change the SI570 clock frequency
si570.dump -- Dump SI570 registers
fpga.dump -- Dump FPGA registers
fpga.pwm1_div -- PWM divider, Freq = 80MHz/(div+1)
fpga.pwm1_duty -- PWM duty cycle
fpga.pwm2_div -- PWM divider, Freq = 80MHz/(div+1)
fpga.pwm2_duty -- PWM duty cycle
fpga.adc_clkdiv -- FPGA Clock Divider for ADC (80 MHz/CLKDIV)
fpga.adc_acqlen -- Num of SCK cycles nCS to AD7357 is held high betewen conversions
ssc.start -- Start the SSC Receiver
ssc.stop -- Start the SSC Receiver
ssc.stats -- Statistics about the SSC
ssc.dump -- Dump SSC DMA registers
-KF
On Jan 20, 2013, at 6:51 PM, Sylvain Munaut <246tnt(a)gmail.com> wrote:
Hi,
You should know that the fw is being rewritten ( branch mci-rewrite ),
to use the MCI interface for data transfer, allowing up to 4 MHz
transfer.
But this will require a HW mod to be detailled later.
Cheers,
Sylvain