As a christmas present a friend of mine showed me some nanoBTS documents, I
can't make copies but I remember some details I will post here ...
LED status codes:
red/steady: sw error, power-on fails
orange/slow flash: ethernet disconnected
red/fast blink: dongle attached, factory reset done
red-green/fast flash: unit not configured
orange/fast flash: code loading in progress
orange/slow blink: TRX is waiting for OML
orange/steady: self test in progress
green/fast flash: OML established, NWL test running
green-orange/slow blink: calibrating in progress
green/slow flash: no radio carrier transmitted
green/steady: operational state
TIB pinout:
Output-connector - pin
1-spare/fpga
2-spare/fpga
3-26mhz -
4-26mhz +
5-sync out +
6-sync out -
7-ppc serial out
8-ppc serial in
9-fpga serial out
10-gnd
Input-connector - pin
1-10mhz in -
2-10mhz in +
3-26mhz in -
4-26mhz in +
5-sync in +
6-sync in -
7-frame sync
8-nc
9-reset
10-gnd
A merry christmas,
WoMax
Show replies by thread