Hi everyone,

Thanks for your help. Now I am able to compile and run the source of osmocmBB. The problem was I had not installed toolchain as a root.

But unfortunately, now I m receiving the same error as I was getting earlier which is as follows: (I am using the "Ja! Mobil" SIM card)

root@neetesh-VirtualBox:/opt/osmocom-bb/src/host/osmocon# telnet localhost 4247 Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. Welcome to the OsmocomBB control interface

OsmocomBB> en OsmocomBB# conf t OsmocomBB(config)# ms 1 OsmocomBB(ms)#no shutdown OsmocomBB(ms)#en OsmocomBB# write Configuration saved to /home/neetesh/.osmocom/bb/mobile.cfg

OsmocomBB# show ms 1

MS '1' is down, radio is not started   IMEI: 000000000000000      IMEISV: 0000000000000000      IMEI generation: fixed   automatic network selection state: A0 null   cell selection state: C0 null

  radio ressource layer state: idle   mobility management layer state: MM idle, PLMN search

OsmocomBB# show subs 1 Mobile Subscriber of MS '1':  No SIM present.

OsmocomBB# sim read 1

OsmocomBB# show subs

Mobile Subscriber of MS '1':  IMSI:  Status: U2_NOT_UPDATED  IMSI detached  LAI: invalid  Access barred cells: no  Access classes: I tried the patches SIM in the firmware provided by  Lukas Kuzmiak available at :

http://baseband-devel.722152.n3.nabble.com/patches-for-SIM-in-the-firmware-t...

But in my first attempt I am getting some error in l23_api.c while I am compileing the osmocomBB source because I think when I am changing the code then I need to recompile and run it. Didi anyone help me on this? Has anybody used this patch earlier? Am i doing something wrong?

With regards

Neetesh Saxena...