Re: JTAG setup for Pirelli DP-L10

Hi,

On 25.07.2013 23:41, ubuntugirl wrote:

• What connector part did you populate on that footprint?

None, actually. I just directly soldered some pieces of enamelled wire to the pads of the footprint.

• What actual JTAG adapter gadget did you use?

I used a Bus Blaster v2, but any other adapter that is supported by OpenOCD and can handle 3.3V levels should work fine. (Actually the Calypso uses 2.8V IO-levels, but 3.3V works anyway).

• How did you connect that JTAG adapter gadget to the phone?

I soldered the wires to a 0.1" pin header, and then used a few 1 pin female-female jumper wires to connect them to the Bus Blaster.

Regards, Steve