On Mon, 2011-05-30 at 23:41 +0200, Drasko DRASKOVIC wrote: ...
OSMOCOM Layer 1 (revision osmocon_v0.0.0-884-gd76345a)
Device ID code: 0xb4fb Device Version code: 0x0000 ARM ID code: 0xfff3 cDSP ID code: 0x0128 Die ID code: 2c903414df039b3f ====================================================================== REG_DPLL=0x2413 CNTL_ARM_CLK=0xf0a1 CNTL_CLK=0xff91 CNTL_RST=0xfff3 CNTL_ARM_DIV=0xfff9 ======================================================================
THIS FIRMWARE WAS COMPILED WITHOUT TX SUPPORT!!!
You might want to compile with transmit support if you expect to be able to make calls and so forth, its explained on the wiki ;)
...
L1CTL_RESET_REQ: FULL!L1CTL_FBSB_REQ (arfcn=121, flags=0x7) Starting FCCH RecognitionFB0 (1735:8): TOA= 9600, Power= -52dBm, Angle= 1218Hz FB1 (1745:8): TOA= 9563, Power= -52dBm, Angle= 174Hz fn_offset=1744 (fn=1745 + attempt=8 + ntdma = 7)m delay=9 (fn_offset=1744 + 11 - fn=1745 - 1 scheduling next FB/SB detection task with delay 9 =>FB @ FNR 1744 fn_offset=1744 qbits=3068 Synchronize_TDMA LOST 3054!
What would this LOST 3054! say ? It does not sound good anyway, but at this point I am not skilled enough to read OsmocomBB logs.
That's fine/normal.
...
PLMN selection in state 'A6 no SIM inserted'
Can somebody explain me what the hell is happening here ?
No SIM inserted ;)
You have 3 options: 1. Check out sylvain's testing branch for a working on-phone SIM driver 2. Use the SAP interface to a PC/SC smartcard reader with SIM inserted. 3. If you want to use GSM test set instead of real network, use test sim functionality of mobile
See the 'sim' commands in mobile vty interface, and also try looking around with enable; configure terminal; ms 1
I am watching all these nice Harald's presentations, like one here : http://www.youtube.com/watch?v=H7rNKZdASBE, but I am not obtaining list of cells like presented to which I can synchronize to. Actually, show cell is giving me :
OsmocomBB> show cell 1 arfcn |MCC |MNC |LAC |cell ID|forb.LA|prio |min-db |max-pwr|rx-lev -------+-------+-------+-------+-------+-------+-------+-------+-------+-------
Should be fine after you solve the two above-mentioned problems. The cell table can be a bit laggy anyway... Sometimes even when everything works it takes a long time to register to the network and I don't get cell info until after that succeeded.
OsmocomBB>
As you can see, I am pretty much lost here and I would highly appreciate helping hand.
Hope that helps.
Gianni