20 Apr
2012
20 Apr
'12
10:08 a.m.
Hi Andreas.
Much appreciation, but one more question. Can OsmocomBB code recognize
any other signals which are non-GSM in the neighborhood of the c123,
for instance, signals generated by radio/TV receivers? How can it be
made to recognize them?
Ojenge
On 4/20/12, Winston Ojenge <wojenge(a)strathmore.edu> wrote:
Hi Andreas,
Much appreciation. I have to do it as long as it's possible. Thanks.
Will update forum on my results progress.
Ojenge
On 4/19/12, Andreas Eversberg <andreas(a)eversberg.eu> wrote:
hi ojenge,
you need to perform two steps:
1. you need to alter the neighbour cell measurement task in
mobile/gsm322.c, so it will not measure neighbour cells in idle mode,
but measure whatever you like. you can define up to 32 frequencies.
after you've received the results, you can keep them, change them or
change them back to start over, until you have measured the full range
you want. you must give <ARFCN> + ARFCN_UPLINK in order to measure other
phones.
2. as you have a complete set of frequencies you wanted to scan, you
need to generate an sms with these results.
note that you cannot sync nor read any messages from the surrounding
phones with the neighbour cell measurement task. you just get the rx
level of what passes through the filters.
also note that the current code will only run on a host, so you need a
laptop/netbook/embedded hardware to use the c123 with osmocombb.
i suggest start reading the gsm322.c, it does most of the idle process.
regards,
andreas