Hi Srdjan.
First of all thank you for support.
We do not have register dump. However, Lime GUI project file used in this
experiment is attached. You can use GUI File->Open
Project option to import
it. I see Ichp and Ichp offset currents are different from defaults but
these still do not justify 5-12dB worse PN in your reports. You can give it
a try though before changing TCXCO.
We will try to adjust Ichp and offset first off all. Thank you for hint.
*Test Description:*
- DC MAX applied through analogue inputs, DACs off
It is quite important detail too.
- TXVGA1 and TXVGA2 at max gain
Similar.
- Loop filter redesigned for 100kHz loop bandwidth and 40MHz reference
- Icp and Icp offset optimized at 25 deg. Same set up used at all
other temperatures
Please inform us values of components for 100kHz BW filter.
But we are forced to
use one clock 26MHz for all because of target price.
- Cap code and VCO picked up by PLL tune routine
I implemented 10kHz BW filter for PLL and found that frequency locking
become
unstable because of calculated VCOCAP value a bit lower then
required (too high capacity).
If VCOCAP incremented manualy (after auto-tuned) then no any problems.
What do you think about it.
And could you please inform me values for 10 kHz BW filter, just to compare
with my calculations.
Best regards,
Andrey Sviyazov.