Transceiver quiting

Hi All, After my initial success early in the week things seems to have gone pear shaped! I cannot get OpenBTS to start reliably as per traces below. After a power cycle of the UmTRX I can normally get OpenBTS to start for a few seconds before the transceiver terminates again. ./transceiver starts and runs on its own OK but there is a lot less traffic in a wireshark trace compared to being started from OpenBTS. When the transceiver starts from OpenBTS a Wireshark trace shows a lot of UDP packets. Approx 460 x 36 byte UDP packets for the first 0.5 seconds Then some variable length UDP packets all ACKed back with 36 bytes After 0.8 from startup the UmTRX sends a 28 byte message: 14d0000700000005000000140000000000a6d5180000000000100100 After approx 1.0s from startup I then only get a few packets back from UmTRX After 5s I get nothing back from UmTRX After 6s I get an ICMP Port Unreachable If I had more time I would look into the transceiver source code to figure out where things are stopping. I suspect this might be a networking issue and have tried changing some Linux kernel buffer settings without success. I have also reset my OpenBTS database just in case I had an option in there causing this. I'll carry on checking out the network side of things but I am starting so suspect there might be an issue with the UmTRX. Help! Regards Craig ALERT 46937531359488 TRXManager.cpp:408:powerOn: POWERON failed with status -1 transceiver: no process killed linux; GNU C++ version 4.1.2 20080704 (Red Hat 4.1.2-52); Boost_104100; UHD_003. 004.000-93a49d0 terminate called after throwing an instance of 'uhd::runtime_error' what(): RuntimeError: no control response *EMERG 1101519168 OpenBTS.cpp:134:startTransceiver: Transceiver quit with status 6. Exiting.* or: ALERT 47613775102208 TRXManager.cpp:408:powerOn: POWERON failed with status -1 transceiver: no process killed linux; GNU C++ version 4.1.2 20080704 (Red Hat 4.1.2-52); Boost_104100; UHD_003. 004.000-93a49d0 ALERT 47832442212256 UHDDevice.cpp:469:open: UHD make failed, device type=umtrx, addr=192.168.1.10,name=UmTRX,serial=13 ALERT 47832442212256 runTransceiver.cpp:95:main: Transceiver exiting... *EMERG 1104513344 OpenBTS.cpp:134:startTransceiver: Transceiver quit with status 256. Exiting.*