Re: tx signal jitter

Alex,

On Thu, Feb 20, 2014 at 11:33 AM, alex korolev nik135@mail.ru wrote:

When i exec 'tx_waveforms.exe --wave-type SINE --wave-freq=100000 --freq=300000000 --rate 1000000 --bw 20000 --ampl 0.7' I get a sine wave at the desired frequency, but it have a jitter. It is a normal behavior?

Most likely this is fine. Check spectrum picture with a spectrum analyzer to see if there is any noise which might cause this.

The little jpeg attached :-)

It's an avi, not a jpeg ;)

ps. I have not found information on calibration, tell me how to make sure that the device is calibrated??

We're preparing a short manual about the calibration. Skilled and impatient could refer to the LMS6002D calibration guide for details.