Darby,
I apologize for the delayed answer - I was traveling to US to do more
demonstrations of UmTRX.
On Fri, Nov 2, 2012 at 5:39 AM, Darby <darbysgoodies(a)gmail.com> wrote:
The only issue
with passive cooling is that we need to make a good
contact between UmTRX and a case. And this requires careful selection
of a proper case and design of mounting. Again - if you or someone
else want to take on this task - we'd be happy use it.
Hmm, Could be doable... Its been a while since Ive done any 3D
design, you know of anything in particular that's free & one could
learn fairly quickly for a project such as this?
Unfortunately I don't know any - never looked at the 3D modeling tools.
I'm not sure whether you actually need a 3D design here? As I see it,
you select a proper existing case and just design front/rear panels
and drilling pattern for mounting. I may be wrong, though - I've never
done this before. I just worry that a fully custom case could be too
expensive in small quantities.
--
Regards,
Alexander Chemeris.
CEO, Fairwaves LLC / ООО УмРадио
http://fairwaves.ru