Hello, All!
1. I'm also (as Andrew Back) interested about calibration methods, but I can not find
calibration technology description.
How i can calibate device?
2. test_pps_input program failed with message:
Using Device: Single USRP:
Device: UmTRX Device
Mboard 0: UMTRX-REV0
RX Channel: 0
RX DSP: 0
RX Dboard: A
RX Subdev: LMS6002D (0xfa07) - 0
TX Channel: 0
TX DSP: 0
TX Dboard: A
TX Subdev: LMS6002D (0xfa09) - 0
Attempt to detect the PPS and set the time...
-- 1) catch time transition at pps edge
Error: RuntimeError: Board 0 may not be getting a PPS signal!
No PPS detected within the time interval.
See the application notes for your device.
Where i can get information about pps signal state and gps lock? (from device)
3. I found that eob (end of burst) metadata does not work, signal at spectrum analyzer is
present, after sendind eob.
How i can mute tx?
thanks for answers ! :-)
С уважением,
alex korolev
nik135(a)mail.ru
Show replies by thread