15 May
2011
15 May
'11
1:01 p.m.
Hi,
The routing has been done. Drawing and gerber are available. As I never work with fabrication, I have no idea if I did it right/wrong. https://gsm.tsaitgaist.info/SIMtrace/v0.9+/
Kevin
On 13.05.2011 10:03, Kevin Redon wrote:
Hi,
The BOM (bill of material) is ready. I finished the netlist, footprint drawing, and footprint selection. all available at : https://gsm.tsaitgaist.info/SIMtrace/v0.9+/
next task : place the components on the board (i'll try smart card size) and route the lines.
Kevin