10 Nov
2016
10 Nov
'16
12:34 p.m.
Hey Felix,
thank you for your answer!
However since holger recommended dfu-util 0.4 I tried the 0.5 version since 0.4 was not
available on the website. With the 0.5 version it works. Hope this helps you as well since
it's easier to flash.
Greetings,
Michael
Am Dienstag, 08. November 2016 17:47 CET, J. Félix Ontañon
<felix.ontanon(a)podsystem.com> schrieb:
Hi Michael,
Just to let you know dfu-util 0.9 didn't worked for me either, but
SAM-BA/sam7utils did!
I just followed this simtrace wiki page instructions to do so (flashing
using libusb): https://osmocom.org/projects/simtrace/wiki/SIMtrace_Firmware
The wiki page has the firmware attached in the format required by SAM-BA. I
compiled it myself with the arm toolchain, though. The tricky part was
switching to SAM-BA mode, what the wiki page says is true: sometimes it
just not works ... After 3 or 4 attempts it worked.
I hope this helps.
Regards.
2016-10-16 22:28 GMT+02:00 Holger Freyther <holger(a)freyther.de>de>:
> On 16 Oct 2016, at 22:15, Michael Kramer <michael.kramer(a)uni-konstanz.de>
wrote:
>
>
> Am Freitag, 14. Oktober 2016 22:19 CEST, Holger Freyther <
holger(a)freyther.de> schrieb:
>
>>>
>>> I've tried both dfu-utils 0.8 and 0.9 on a debian and kali machine.
Haven't used SAM-BA yet. Should I try that as well?
>>
>> SAM-BA is a lot more inconvenient and slower than dfu-utils. Could you
try an older version of dfu-utils? E.g. I started with dfu-utils and probably still have this version around.
used
in
> the past.
>
> holger
Could you maybe check which version it was?
oh. I did and then didn't write it down. It was dfu-util 0.4 that I have