Attention is currently required from: laforge. tnt has posted comments on this change. ( https://gerrit.osmocom.org/c/osmo-e1d/+/27016 )

Change subject: Allow configuration of interfaces/lines via VTY ......................................................................

Patch Set 2: Code-Review-1

(1 comment)

Patchset:

PS2: It fails to re-read the config files it write.

<0000> intf_line.c:154 (I0) Created <0000> intf_line.c:251 (I0:L0) Created There is no such command. Error occurred during reading the below line: mode CHANNELIZED

<0000> osmo-e1d.c:183 Failed to parse the config file 'osmo-e1d.cfg'

The watchdog running for interfaces that are in the config but not connected is also kind of annoying, but then again it's the same for when the link is down, I think there is another issue for that.