lynxis lazus has uploaded this change for review. ( https://gerrit.osmocom.org/c/simtrace2/+/27406 ) Change subject: firmware: usb: call USBD_HAL_DISCONNECT while usb init to recover from resets: ...................................................................... firmware: usb: call USBD_HAL_DISCONNECT while usb init to recover from resets: The firmware doesn't recover from a OSMO_ASSERT() which direct reset the board. After the reset the firmware will waits forever for the USBD state USBD_STATE_CONFIGURED. By adding the explicit USBD_HAL_DISCONNECT the board always recovers. Fixes: OS#5478 Related: SYS#5752 Change-Id: I600a26025166d20b6b27c191f24e4023efdaadf6 --- M firmware/libcommon/source/usb.c 1 file changed, 1 insertion(+), 0 deletions(-) git pull ssh://gerrit.osmocom.org:29418/simtrace2 refs/changes/06/27406/1 diff --git a/firmware/libcommon/source/usb.c b/firmware/libcommon/source/usb.c index d86fc92..3b645e2 100644 --- a/firmware/libcommon/source/usb.c +++ b/firmware/libcommon/source/usb.c @@ -689,6 +689,7 @@ { unsigned int i; /* Signal USB reset by disabling the pull-up on USB D+ for at least 10 ms */ + USBD_HAL_Disconnect(); USBD_HAL_Suspend(); mdelay(500); USBD_HAL_Activate(); -- To view, visit https://gerrit.osmocom.org/c/simtrace2/+/27406 To unsubscribe, or for help writing mail filters, visit https://gerrit.osmocom.org/settings Gerrit-Project: simtrace2 Gerrit-Branch: master Gerrit-Change-Id: I600a26025166d20b6b27c191f24e4023efdaadf6 Gerrit-Change-Number: 27406 Gerrit-PatchSet: 1 Gerrit-Owner: lynxis lazus <lynxis(a)fe80.eu> Gerrit-MessageType: newchange