Hi ... I successfully ran asterisk with a cluster in FP mode with one handset. Now I tried to use asterisk acting as a PP so that it can accept calls from PSTN. I catched EMC and FPN of my base station via dect-llme-scan. Where do I pass the PIN code for access_rights_requests? When I want to start asterisk I get following error messages: netlink: cu: mode PP ARI: class A: EMC: 0d13 FPN: 126f4 netlink: FPC: full_slot,page_repetition,basic_a_field_setup,in_min_delay netlink: HLC: adpcm_g721_voice,gap_pap_basic_speech,standard_authentication,location_registration LCE: set default pmid e16c8 LCE: registered protocol 0 (Link Control) LCE: registered protocol 3 (Call Control) LCE: registered protocol 4 (Call Independant Supplementary Services) LCE: registered protocol 6 (ConnectionLess Message Service) LCE: registered protocol 5 (Mobility Management) netlink: MAC_ME_RFP_PRELOAD-req netlink: HLC: adpcm_g721_voice,gap_pap_basic_speech,standard_authentication,standard_ciphering,location_registration,ciss_service,clms_service,list_access_features [Nov 1 11:44:09] ERROR[3477]: chan_dect.c:2338 dect_load_module: Unable to set FP capabilities == Unregistered channel type 'DECT' Kind regards TheNoOne