Hi Alexander.
Actualy I don't know side-type connectors for cable.
I suggested you PCB side connector (like PCI) for debugging only.
Moreover, there are a lot SMD connectors for IDC flat cable, BHS-10 for
example.
Best regards,
Andrey Sviyazov.
19 марта 2012 г. 10:14 пользователь Alexander Chemeris <
alexander.chemeris(a)gmail.com> написал:
Andrey,
2012/3/19 Andrey Sviyazov <andreysviyaz(a)gmail.com>om>:
5) Regarding connectors, I only can suggest to
use the two angle
SMA-female
connectors for outputs which will stick out
through the panel of the
housing
(as you can use the angle SMA connectors, but for
GPS and CLK_I/O on the
UmTRX board). At the same time for the internal 4 connectors we can use
some
cheap like U.FL and cable assemblies U.FL-MCX or
U.FL-U.FL. Signal
CLK_26MHz, 6.5VDC, SPI and Switch controls will go via IDC control
connector.
IDC connectors on a UmTRX and on a RF board will be connected with a
flat ribbon cable?
Why don't you want to use a side connector?
--
Regards,
Alexander Chemeris.
CEO, Fairwaves LLC / ООО УмРадио
http://fairwaves.ru