Actualy I don't know side-type connectors for cable.

I suggested you PCB side connector (like PCI) for debugging only.

Moreover, there are a lot SMD connectors for IDC flat cable, BHS-10 for example.

Best regards,

Andrey Sviyazov.

19 марта 2012 г. 10:14 пользователь Alexander Chemeris <alexander.chemeris@gmail.com> написал:

Andrey,

2012/3/19 Andrey Sviyazov <andreysviyaz@gmail.com>:

> 5) Regarding connectors, I only can suggest to use the two angle SMA-female
> connectors for outputs which will stick out through the panel of the housing
> (as you can use the angle SMA connectors, but for GPS and CLK_I/O on the
> UmTRX board). At the same time for the internal 4 connectors we can use some
> cheap like U.FL and cable assemblies U.FL-MCX or U.FL-U.FL. Signal
> CLK_26MHz, 6.5VDC, SPI and Switch controls will go via IDC control
> connector.

IDC connectors on a UmTRX and on a RF board will be connected with a
flat ribbon cable?

Why don't you want to use a side connector?

--
Regards,
Alexander Chemeris.
CEO, Fairwaves LLC / ООО УмРадио
http://fairwaves.ru