Sorry I do not fully understand where to change the
signal strength... in my
file open-bsc.cfg in section trx , nominal power is equal to 23. Where
should I make changes ?
In regards to setting gain, would it be a call to this function?
src/target/firmware/rf/trf6151.c:146
int trf6151_set_gain_reg(uint8_t dbm, int high)
I found that rffe_set_gain is the only caller of trf6151_set_gain_reg and
the only caller of rffe_set_gain seems to not be adjusting the gain based
on any measurements.
So maybe there needs to be new code which adjusts the gain?
-Craig