1 Nov
2011
1 Nov
'11
12:28 p.m.
hi dieter,
i like to clean up and merge the sim reader code with master branch.
while looking at the code i found a delay_ms(1) in interrupt handler:
-------
/* Used by: calypso_sim_transmit() to transmit the data */
if(regVal & REG_SIM_IT_SIM_TX)
{
#if (SIM_DEBUG == 1)
puts(" Waiting for transmit...\n");
#endif
if(sim_tx_character_count >= sim_tx_character_length)
{
txDoneFlag = 1;
}
else
{
writew(*tx_buffer,REG_SIM_DTX);
tx_buffer++;
sim_tx_character_count++;
#if 1 /* Dieter: set to 0 to get problems with some cards */
/* its essential to immediately switch to RX
after TX is done */
if(sim_tx_character_count >=
sim_tx_character_length)
{
/* TODO: set a proper delay here, 4 is to
long if not debugging and no delay is
too short */
delay_ms(1);
/* Switch I/O direction to input */
writew(readw(REG_SIM_CONF1) &
~REG_SIM_CONF1_CONFTXRX, REG_SIM_CONF1);
}
#endif
}
}
---------
i removed the delay, and it works. i checked the tsm30 source code. it
also sets the IO to input right after writing the last TX byte. (i guess
that the controller will trigger the IO switching at the end of
transmission.) so why do we need that delay? are there any problems?
regards,
andreas