Hello,
I've found a very interesting article about SciphoneDream G2 published on your webpage
at
http://bb.osmocom.org/trac/wiki/SciphoneDreamG2 that covers pretty detailed information
about MT6235 SoC, bootstrapping as well as JTAG. This is the only article I have ever
found on internet about MTK SoC and JTAG.
What I am trying to accomplish is to access NAND flash and write to it over JTAG (in order
to recover from corruption after bad flash) on MTK8555 SoC which according to my in-depth
research and analysis has very similar architecture to MT6235. If I can't write to
NAND over JTAG but would be able to launch u-boot that would be a solution too. I am very
good at ARM assembly and debugging, however I am not very experienced with JTAG. Do you
think you (or anyone else) could help me out, by giving me guidance what hardware,
software, config files should I use to make JTAG work on this SoC ? Any help or advise
would be more then appreciated!
If you are a wrong person I contacted, I apologize for the inconvenience.
Many thanks in advance!
Dwayne