Hi Prasad,
Let me know the procedure for download of binaries to
target
1) Stop BTS and PCU services by typing 'systemctl stop sysmobts' and
'systemctl stop sysmopcu', respectively
2) Copy sysmobts, sysmobts-mgr and osmo-pcu binaries from your remote host to /usr/bin
3) Start BTS and PCU services by typing 'systemctl start sysmobts' and
'systemctl start sysmopcu', respectively
other details of integration test setup, For example
- other components to be connected to target (Any mandatory components like GPS)
Connect GPS antenna to SMA connector (yellow) near the power supply connector.
- board configuration details
GSM Rx and Tx
antennas are required to connect to Rx and Tx ports of the LC10 unit, respectively.
(Tx antenna must be able to handle at least 5W of Tx power)
- debug terminal connections
Via SSH, you need
to know IP address of the target boards ( master & slave) inside the LC10 unit
(DHCP lease list in your network DHCP server will tell IP address associated with MAC
address labeled on chassis of the LC10 unit)
- LAN1 /LAN2 connection usage details
You can
use any of them.
- precautions to be taken
Make sure both Tx
and Rx antennas are properly connected before powering cycle the unit.
Minh-Quang Nguyen
Concepteur logiciel | Software designer GSM/Network
T. 418 914-7484 x2296 | 1 855 914-7484 | F. 418 914-9477
2150, Cyrille-Duquet, Québec (Québec) G1N 2G3 CANADA
minh-quang.nguyen(a)nutaq.com
www.nutaq.com
QUEBEC MONTREAL NEW YORK
Facebook Twitter LinkedIn YouTube
-----Original Message-----
From: Prasad Kaup [mailto:Prasad.Kaup@radisys.com]
Sent: Tuesday, March 22, 2016 9:38 AM
To: Minh-Quang Nguyen; Neels Hofmeyr; osmocom-net-gprs(a)lists.osmocom.org
Cc: Saurabh Sharan; Yves Godin; Abhinav Pragya Rishi
Subject: RE: Regarding integration of NURAN L1 1.0
Hi Minh-Quang Nguyen,
Thanks for the information. I see from the site that Sourcery CodeBench Lite
releases for ARM EABI is no longer available. Instead there is a trial version of
Sourcery CodeBench for ARM available. We have downloaded it and trying to use it.
Let me know the procedure for download of binaries to target and other details of
integration test setup, For example
- other components to be connected to target (Any mandatory components like GPS)
- board configuration details
- debug terminal connections
- LAN1 /LAN2 connection usage details
- precautions to be taken
Regards
Prasad