25 Feb
2010
25 Feb
'10
3:48 p.m.
hi,
check if you selected the right timeslot for d-channel: use "dslot=1"
(old driver) or "layermask=0x02" (newer driver) when loading the
hfcmulti.ko.
use "--debug=DMI" and loop your line (connect pin 1 to pin 4, and pin 2
to pin 5). do you get activation-message when looping? if not, be sure
to shift all jumpers toward the slot cover.
if you see the loop, but no activation-message after booting BS11 (takes
about 15 minutes), swap connector 1 and 2. one connector must be
connected to pin 1 and 2, and the other to pin 4 and 5.
andreas
________________________________
Von: openbsc-bounces(a)lists.gnumonks.org
[mailto:openbsc-bounces@lists.gnumonks.org] Im Auftrag von Ihab el Bakri
Gesendet: Donnerstag, 25. Februar 2010 14:59
An: openbsc
Betreff: bsc_hack
Hello there,
finally, got nearly everything to work, but am unable to see the network
on my mobile and am getting this message when running bsc_hack with a
config file :
DB: Database initialized.
DB: Database prepared.
1 device found
id: 0
Dprotocols: 00000018
Bprotocols: 0000000e
protocol: 4
nrbchan: 30
name: hfc-e1.1
activate bchan
activate bchan
<000c> trau_frame.c:116 can't decode unknown TRAU Frame Type 0x00
Thank in advance
Ihab el Bakri