Hi,
I found out that the main reason for not being able to connect is TX power and not RX
gain. By setting tx-power to ‘0' instead of ‘auto’ I solved my issue. Although I still
think that the sensitivity is not perfect.
Best regards,
On Jul 30, 2016, at 4:31 PM, Vadim Yanitskiy <axilirator(a)gmail.com> wrote:
Hi Robert,
There are many possible issues, which can cause your problem.
So, it would be good to see more details. Please, prepare two
measurements using cell_log application: one inside any
building, and another one outside. Attach both outputs from
the cell_log and from the osmocon.
I have several phones, and some of them have different RX
signal level. I think, it's due to individual calibration
tables, which aren't used in OsmocomBB firmware.
BTW: if your phone's case is open, make sure that antenna is
connected to the phone's board.
With best regards,
Vadim Yanitskiy.