OsmocomBB - C155 - stuck at flashing firmware

Greetings, I have been working with OsmocomBB with C155 model. After a lot of reading and understanding issues on mailing list, following the right instructions I am unable to understand where the problem is - cable or the locked tracfone C155 or my setup. I was successfully able to build the project. I am stuck on executing the following command ~/osmocom-bb/src/host/osmocon# ./osmocon -p /dev/ttyUSB0 -m c155 ../../target/firmware/board/compal_e99/layer1.compalram.bin <No output at all> <Even on slight push on power button no output> Please find my specifications and findings below: 1. C155 locked tracfone. 2. FTDI adapter USB serial from - Fonefunshop Is there a way to test the FTDI adapter ? dmesg - list that FTDI adapter attached to ttyUSB0. FTDI VCP driver is built into the Linux kernel. Do I need D2XX driver ? 3. I'm trying to write the firmware (layer1) with a working GSM sim inside and not tracfone sim card. 4. strace gives me no trouble other than this access("/etc/ld.so.nohwcap", F_OK) = -1 ENOENT (No such file or directory) - Is it a worry ? 5. When I execute ./osmocon with all necessary params. I open a new console and type the following ./osmoload memdump 0x000000 0x2000 dump. - Is this valid at this point? just to see where the actual firmware is located at? Dumping 12288 bytes of memory at 0x0 to file dump - Nothing gets dumped into file dump Although, I see some output - 'got 2 bytes from modem... ' in the osmocon window - ./osmocon It would be very kind if someone could guide me. How do I verify there is a cable issue <Any software to test TX> since I have bought these and if not the cable them am I doing something wrong ? Looking forward to the reply! Thanks, Gerard. -- View this message in context: http://baseband-devel.722152.n3.nabble.com/OsmocomBB-C155-stuck-at-flashing… Sent from the baseband-devel mailing list archive at Nabble.com.