Linux + u-boot port to MT6235

Hi All! That's true, I managed to run U-Boot on MT6235, but linux kernel is not fully functional yet (it's fresh stuff as I managed to ran it on Tuesday and then I was off to conference). For MT6235 development I chose Sciphone G2, which is pretty cheap. After some time I managed to download code to SRAM (just 64KB) using MTK's FlashTool. MTK FlashTool communicates over UART directly with MT6235 bootloader and sends its own chunk of code (about 58KB) which is executed in SRAM and communicates with FlashTool. I found on pudn.com some pack to customize code loaded by FlashTool, thanks to which I could download my own code to SRAM (without JTAG). The problem was that it had to be linked with some security libraries which occupied about 56KB and not much memory left for my own code. Then I decided to try find JTAG pins to get all control on MT6235. That took me sometime, but finally I succeeded. The other bigger issue was initializing DRAM controller to be able to download bigger code (linux kernel + uboot) to external RAM. In sciphone there is problem that all interesting chips are under metal shield which is pretty havily soldered. In this case I couldn't read what kind of RAM memory is mounted without destroying the board (I don't have such soldering machine which could unsolder so big metal shield). Thanks to JTAG I could attach to target and then dump DRAM controller registers from processor running MTK's software, but setting these values after processor start and configuration of PLL didn't work. I decided to disassemble bootloader which could show me how DRAM controller is initialized and how code fron NAND is loaded (to be able to flash U-Boot and kernel to NAND so MT6235 will start my code automatically and I will not have to use JTAG). Currently I have knowledge how internal MT6235 bootloader is loading code from memory during startup and I also extracted procedure of DRAM controller initialization. Thanks to that I'm able to run U-Boot from the very begining of processor startup. The problem is that I have just one piece of Sciphone G2 and I don't want to flash it yet to not break existing code in it. Thanks to running device I'm able to attach with JTAG and check how peripherals are configured (i.e. LCD, MMC, etc.). I have backup of flash, but I'm not 100% sure if I will flash it back, phone will startup. That's why I bought second piece of Sciphone G2 and should receive it today or on Tuesday (this Monday is holiday in Poland). In this case I'll flash U-Boot to NAND and try to make it working. Then we could load the rest of code from U-Boot (to RAM or NAND over serial). You can see how my setup looks on attached picture. The good thing about it is that the same bootloader is used in MT622x, so it should be fairly easy to do the same on phones based on that SoCs (but unfortuantely it's just ARM7). If it comes to code, of course I can share it on "git.osmocom.org". Currently it's just basic port of U-Boot and not much for linux kernel, but I'm working on this now so I'll push it when it'll be ready. Currently I'm working on driver for NAND memory for U-Boot, so we could flash linux kernel. When that will be ready I'll push the code. Then I'll switch to linux kernel and when it'll be functional I also push the code. At this stage you will not need to have JTAG and you could load the code over serial in U-Boot. If it comes to GSM I didn't work with it before. I actualy worked 6 months in L2/3 team for LTE (on RRC) but it's different story. That could be really outstanding thing if we could run first phone ever with whole code open (from BB up to APP). BR, Marcin