Is My RTL2838U + R820T Tuner working?

Hello! I received my USB-DVB-T+DAB+FM dongle last week, and have been trying to find a signal with it since, but with no luck. Can anyone tell me how to tell if it is working at all? I'm using the Windows version of Osmocom under WinXP. Using rtl_eeprom, I get the following display: -------------------------- Vendor ID 0x0bda Product ID 0x2838 Manufacturer Realtek Product RTL2838UHIDIR Serial Number 00000000001 Serial Number Enabled Yes IR Endpoint Enabled Yes Remote Wakeup Enabled No ----------------------- When I run rtl_test -s 1.6e6 I get the following response: ----------------------- Found 1 device(s) 0: ezcap USB 2.0 DVB-T/DAB/FM dongle Using device 0: ezcap USB 2.0 DVB-T/DAB/FM dongle Supported gain values(29): 0.0 0.9 .... 49.6 Info: This tool will continuously read from the device, and report if samples get lost. If you observer no further output, everything is fine. Reading samples in async mode... -------------------------- If at that point after a while I press Control C, I get --------------------------- Signal caught, exiting! --------------------------- But then my command prompt window hangs up and will do nothing until I close it all together. Does it appear that my dongle is working? Where do I find out how to use the different gains that are listed by rtl_test? Could my difficulties have anything to do with the fact that my dongle is IR Endpoint enabled? I am brand new to this, and haven't had much luck so far, although I think I've gotten further with Osmocom and Windows than with anything else I've tried. Any help/advice/links to more information will be much appreciated. Sorry for the long post -- I was trying to provide as much information as I could. Thanks Curt Carpenter