Mis-detected E4000 instead of FC0013 tuner when using NOXON DAB Stick on Raspberry Pi

Hello Guys, First of all: I am amazed by your project - many ideas come up in my head what can be done with this tiny cheap SDR. I have tested rtl_sdr with a linux-vm on my Mac successfully but wanted to run it on my raspberry pi. Unfortunately and thithout an explainable reason to me the tools detect an E4000 instead of the soldered FC0013 on my stick - but only on the PI. To fix this issue I have changed the detection order in librtlsdr.c: diff --git a/src/librtlsdr.c b/src/librtlsdr.c index 3a67b53..cb34f1d 100644 --- a/src/librtlsdr.c +++ b/src/librtlsdr.c @@ -1073,13 +1073,6 @@ int rtlsdr_open(rtlsdr_dev_t **out_dev, uint32_t index) /* Probe tuners */ rtlsdr_set_i2c_repeater(dev, 1); - reg = rtlsdr_i2c_read_reg(dev, E4K_I2C_ADDR, E4K_CHECK_ADDR); - if (reg == E4K_CHECK_VAL) { - fprintf(stderr, "Found Elonics E4000 tuner\n"); - dev->tuner_type = RTLSDR_TUNER_E4000; - goto found; - } - reg = rtlsdr_i2c_read_reg(dev, FC0013_I2C_ADDR, FC0013_CHECK_ADDR); if (reg == FC0013_CHECK_VAL) { fprintf(stderr, "Found Fitipower FC0013 tuner\n"); @@ -1088,6 +1081,13 @@ int rtlsdr_open(rtlsdr_dev_t **out_dev, uint32_t index) goto found; } + reg = rtlsdr_i2c_read_reg(dev, E4K_I2C_ADDR, E4K_CHECK_ADDR); + if (reg == E4K_CHECK_VAL) { + fprintf(stderr, "Found Elonics E4000 tuner\n"); + dev->tuner_type = RTLSDR_TUNER_E4000; + goto found; + } + /* initialise GPIOs */ rtlsdr_set_gpio_output(dev, 5); After compiling the lib the FC0013 is detected and the sticks works great on my Pi. Of course this is not a perfect solution and I will figure out later in depth WHY the E4K_CHECK_VAL comes out of the FC0013. Anybody else who has or had the same problems? the Hardware used is: Bus 001 Device 004: ID 0ccd:00b3 TerraTec Electronic GmbH NOXON DAB/DAB+ Stick regards Christoph