Multiple BTS's on one one E1?

Hello all, I'm attempting to connect multiple BTS's to one E1 card. Each BTS is a single TRX and I'm using a dahdi card plugged into a DCS. The DCS maps the channels as follows: Name Src Dest Speed Type -------------------------------------------------------------------------------- bscnok1 01.T1E1-A.02.01 01.T1E1-A.03.01 0256k D FDX bscnok2 01.T1E1-A.02.05 01.T1E1-A.04.01 0256k D FDX bscnok3 01.T1E1-A.01.09 01.T1E1-B.01.01 0256k D FDX So essentially: TS 1,2,3,4 from OpenBSC (T1E1-A-02) are mapped to nok1 1,2,3,4 (T1E1-A-03) TS 5,6,7,8 from OpenBSC (T1E1-A-02) are mapped to nok2 1,2,3,4 (T1E1-A-04) TS 9,10,11,12 from OpenBSC (T1E1-A-02) are mapped to nok3 1,2,3,4 (T1E1-B-01) This all works fine. The BTS operates on TS1,2,3,4 on any of the ports I have configured. I just swap timeslots in openbsc.cfg from 1,2,3,4 to 5,6,7,8 or 9,10,11,12 and everything is happy. Where I run into a problem is when I try to actually run multiple BTS's at once. So I take everything defined in "bts 0" and duplicate it as "bts 1". I change the time slots for oml, rsl, and traffic channels to match the appropriate channels for bts 1/2. But when I go to start osmo-nitb I get an error that it can't open /dev/dahdi/1 because it's already in use. It appears for some reason that it's attempting to open /dev/dahdi/1 for both BTS's even though only bts 0 uses /dev/dahdi/1 for OML - bts 1 should use /dev/dahdi/5 and bts 2 should use /dev/dahdi/9. My /etc/dahdi/system.conf is defined as: span=1,1,0,ccs,hdb3,crc4 bchan=2-4,6-8,10-12 dchan=1,5,9 I'm at a loss. Has anyone tried to run multiple BTS's with dahdi on a single E1 or T1 span? Is there something special I need to specify so that OpenBSC doesn't grab the first dchan for each BTS? Thanks, Gus