Hello Everybody,
I'm just trying to connect the E-1 host card to the BS-11, but I can't
get it work. The serial connection works fine, I'm also seeing the
"Abis-link: Restoring" message.
My hardware configuration:
1) I removed the green jumpers TB01 - TB04
2) Jumper settings below the Twinax-board: 1-4 ON, 5-8 OFF
3) HFC-E1: NT Mode, Config A (all jumpers on the left side to the left)
4) 'hfcmulti' modprobed with 'dslot=1'
5) Forced the BS-11 to use correct TEI and E1 slot by using 'bs11_config'
Have I missed something? I put a scope upon the rx/tx pins - traffic
flows into both directions, so I think there's no collision (tx->tx, rx->rx)
Thanks,
Holger