Re: Problem testing E1 link

Well i tried every possibilities with the jumpers giving the same result: red steady at start and red blinking after bsc_hack. Following the jumper plan http://www.beronet.com/download/docs/BNXE1/BN1E1_Jumperplan.pdf I should normally have: C2 on the left (pin 1,2,4,5) C1 on the right (NT) D-1: 1-ON / 2-OFF So I came back on my first jumper configuration. I checked also the RJ45 link on my BTS - Y01 PCM in (from BSC): RJ45 pin 4,5 - Y02 PCM out (to BSC): RJ45 pin 1,2 which is Y01 : blue/white blue and Y02 : orange/white orange for a straight cable I noticed something else but don't know if will help: After reboot, when launching bsc_hack for the first time, the protocol is 0 and, when launching bsc_hack after, it's everytimes equal to 4. Best regards Eric Cathelinaud 2009/5/25 Eric Cathelinaud <e.cathelinaud(a)googlemail.com>