Well good news bad news.
Good news: I got the repeater working with analog (ctcss) or p25 input.
Bad news: it shows up on my bcd396xt as "ENC" (encrypted). My Astro Saber
also shows its receiving a signal, but the light flashes in sets of two
(i'm guessing it thinks the signal is encrypted too). The saber's LED only
lit up once I got the levels right.
I did run into this problem in an earlier version of op25 when trying the
op25_audio_tx, but using the latest version seemed to take care of that
problem.
Any ideas Max? Is there something in the source I can tweak without
rebuilding the whole thing?
-Ryan
On Fri, Dec 27, 2013 at 9:15 AM, Ryan Schilder <rjschilder(a)gmail.com> wrote:
Ok thanks for the heads up. I'll clone another
op25 vm and route the "Tx"
audio from the first vm into op25_audio_rx.py on the second vm. I think
there are enough tools to check out the signal. Hopefully i'll have
something to report in the next day or two!
-Ryan
On Fri, Dec 27, 2013 at 7:31 AM, <ikj1234i(a)yahoo.com> wrote:
Sounds excellent - will look forward to reading your report!
One thing to note, the soundcard_tx TX stack utilizes a different
waveform generation algo than the previous TX that you were using. This
one uses table lookups - for efficiency but may be different spectrally.
Might not be a bad idea to keep an eye on things using a spectrum
analyser - if one is available...
73
Max