Quoting wllmbecks(a)gmail.com:
I didn't pay particular attention to the original
post but a (-q 2)
would really be unheard of with an Airspy device
unless it is way out of calibration. I suspect that the spike
you're seeing in is not a "real' signal.
The -q 2 for PPM of 2, is based on another programs output of its auto ppm.
I will try with 0 as well. But with the 2 it was producing audio etc..
Although it's hard to reproduce on demand, I have run into
conditions where my FFT plot displayed a spike at the
center of the spectrum that turned out to be false signal.
Removing the antenna and setting the LNA and Mixer gain
controls to zero made no difference in the amplitude of the spike at
the center of the spectrum.
This is not a spur, or anything of the like. Disconnect the antenna,
its gone. I am not any sort of OP25 guru etc.... but lets just say
this ain't my first rodeo in RF.... :) :) ;)
As a suggestion, retest rx.py using (-q 0) as a
starting point but
add (-X) to let op25 try to resolve tuning errors to
see if you're actually getting a live signal, and check to see that
op25 indicates it's decoding trunk signaling blocks
and live traffic.
Op25 does already indicate its a live signal, just 20-40db down. I get
audio, TSBKS, using a -v10 I get the slew of decoded TSBK data, with
an occasional CRC error. Which is related to the low signal.
I am also not working from a guess on the frequencies of the
system(s). Lets just leave it at that I've got more knowledge about
what frequencies and towers these things are using that a certain
other site and the FCC does. :) ;) ;)
Raising and lowering LNA, MIXER, and IF gains should
result in
varying signal amplitude as observed in the FFT plot
Typically, on my Airspy devices the IF gain maxes out at about a
setting of 8-10 as far as increasing signal amplitude
and whereby increasing IF gain only serves to raise the apparent
noise floor and sometimes introducing unwanted
IM products. But LNA and MIXER gains should play a very significant
role in the signal level as observed in the FFT plot
I think in another setup I am about 10-12 for LNA, and 8-7 on the IF
and MIX as I recall. As I played to max signal and reduce the noise
floor. I'll have to find my note on it.. its not on this box.
I think the other post to disable what ever those modes are is the
key.. which when its reset, ie: powered off and moved to another box,
my OP25 setups is not that box since op25 is not Python3 compatible,
yet, and so I move it to the 18.04, with the ulitimate goal to
possibly move it to a Pi(s), which I was hoping to dump, but there is
a bug in another program to use them there. I am guessing the firmware
of the AS's resets it to use these modes??? Where as the other program
stores those settings and likely restores them when it sees the same
tuner... as it does this with RTL's...
We'll see what the tests do with the magic disable commands....