Hi,
At 01.07.2010 23:37, Maciej Grela wrote:
Here are the steps I'm taking:
1. Run osmocom:
2. Press power on the phone.
Before step 2, start the upper layer application, e.g.
host/layer23/src/mobile
3. Phone boots and downloads code from osmocon (this
code lands in RAM
I presume)
Right, the code is loaded to the internal SRAM of the Calypso DBB.
What is the layer1 firmware supposed to do now ?
I've tried to run
layer23/bcch_scan and layer23/layer23 but they don't print any
messages and so does the firmware itself. I'm under the impression
that the firmware freezes. Have you tested the firmware on a C118
phone ? I will try to find out why it's freezing but maybe I'm missing
something obvious ?
Basically layer23, bcch_scan and mobile wait for the layer1 reset
message, thus have to be started before powering on the phone.
Regards,
Steve