can't get SAM7-p64 board into SAM-BA
I tried to load the dfu.bin+main.bin (=samba) onto the Olimex SAM7-P64 board. I connected jumper TEST for >10s, disconnected power, reconnected power. I assume that it is possible now to upload firmware using sam-ba (i tried both linux and windows) over the USB port. Even trying to connect through the dbg serial port failed. Is there something wrong with the board or in the procedure I follow. Should I see a USB-CDC serial port when the SAM7 is running the SAM-BA bootloader? Any comments would be appreciated.
Hi Stefan, On Tue, Dec 21, 2010 at 12:47:22AM +0100, Stefan Op de Beek wrote:
I tried to load the dfu.bin+main.bin (=samba) onto the Olimex SAM7-P64 board. I connected jumper TEST for >10s, disconnected power, reconnected power. I assume that it is possible now to upload firmware using sam-ba (i tried both linux and windows) over the USB port. Even trying to connect through the dbg serial port failed. Is there something wrong with the board or in the procedure I follow.
The procedure is fine, I also suspect some hardware problem, to be honest.
Should I see a USB-CDC serial port when the SAM7 is running the SAM-BA bootloader?
Yes -- - Harald Welte <laforge@gnumonks.org> http://laforge.gnumonks.org/ ============================================================================ "Privacy in residential applications is a desirable marketing option." (ETSI EN 300 175-7 Ch. A6)
participants (2)
-
Harald Welte -
Stefan Op de Beek