This is merely a historical archive of years 2008-2021, before the migration to mailman3.
A maintained and still updated list archive can be found at https://lists.osmocom.org/hyperkitty/list/baseband-devel@lists.osmocom.org/.
Steve Markgraf steve at steve-m.deHi, On 25.07.2013 23:41, ubuntugirl wrote: > * What connector part did you populate on that footprint? None, actually. I just directly soldered some pieces of enamelled wire to the pads of the footprint. > * What actual JTAG adapter gadget did you use? I used a Bus Blaster v2, but any other adapter that is supported by OpenOCD and can handle 3.3V levels should work fine. (Actually the Calypso uses 2.8V IO-levels, but 3.3V works anyway). > * How did you connect that JTAG adapter gadget to the phone? I soldered the wires to a 0.1" pin header, and then used a few 1 pin female-female jumper wires to connect them to the Bus Blaster. Regards, Steve